Zanussi TD not drying

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi TD not drying

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • February 26, 2020 at 5:24 pm #97263
    pmb
    Participant

    Hi I have a Zanussi ZDC8202P (91609737900) which is not drying for the owner, she finds the washing cold and wet and the filter damp.
    When I set it to a timed cycle it heats. I have checked the airways. The TOC has been drilled to allow it to be reset on a previous repair a year ago. Has anyone got some pointers please and a service manual?
    Thanks, Darren

    February 27, 2020 at 12:36 pm #466707
    iadom
    Moderator

    Send me your email address via PM and I will see what I can find.

    If you have a gmail address that would be best.

    Jim.

    February 27, 2020 at 1:39 pm #466708
    iadom
    Moderator

    have sent you a link to the file on my Google Drive, let me know if that works.

    Jim.

    March 2, 2020 at 5:12 pm #466709
    pmb
    Participant

    Thanks again Jim. This hasn’t got a display. I have put it into test mode and got a fault code but unfortunately I can’t find an explanation of 11 red flashes and 14 yellow. I have looked really closely at the PDF but I can’t see information on how to work out the fault code if it’s over 10 flashes. Can anyone help?
    Thanks, Darren

    March 2, 2020 at 6:12 pm #466710
    iadom
    Moderator

    It really is a nightmare with Lux stuff, it looks as though the answer is on page 61 of that manual but I’m damned if I can work it out from that? There are a couple of other ‘service manuals’ for that model I will have a quick look at those as well. Does yours have any other model names on the front?

    March 2, 2020 at 6:27 pm #466711
    iadom
    Moderator

    Reading the other diagnostics manual doesn’t show anything different. Are any of the status lights flashing at the same time as the Start/Pause button?
    There are 10 separate diagnostics tests, did you run each one?

    March 2, 2020 at 7:42 pm #466712
    electrofix
    Moderator

    cant see that alarm code being correct

    if i am reading it correct thats

    red 11 flashes thats hexidecimal B
    yellow 14 flashes thats hexidecimal E

    fault EBE is LIne safe alarm and since this stop execution no programme would run

    Dave

    March 2, 2020 at 9:42 pm #466713
    pmb
    Participant

    Thanks for getting back to me. Yes I did all the tests but got that code off before so it didn’t get replaced by E32. It was just the start light flashing. I will go back and try again and see if I get a different one

    March 7, 2020 at 11:51 pm #466714
    rub
    Participant

    You will always get e32 during diagnostics as this just shows there is no circuit between paddle sensors( which will be the case unless there is wet washing in or you have manually bridged them out. It will either be an ntc or pcb issue.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.