- This topic has 6 replies, 5 voices, and was last updated 20 years, 10 months ago by
.
-
Posts
-
got the above fridge- freezer fault is with the fridge it runs for 4days at +2 and freezer at -22 then fridge will jump upto +13 for 2 days then settle it self back down to normal temp. then starts all over again 4 days fine 2 days not and so on any 💡
regards tonyRe: hotpoint ff72s
Thermistors, fridge door not hitting the fan switch ??
Forum search function 😉
Dave.
Re: hotpoint ff72s
Hi Tony
Had this before, its a PINTA.
Check the seal on the baffle control housing at the rear wall/ceiling of fridge and also round the cable entry holes.
If the seal is poor cold air passes directly onto the thermistor when the baffle is open. This causes baffle to close too early giving warmer fridge temp than actually set!
Steve
Re: hotpoint ff72s
have a check of the condenser fan, check if its says ‘thermal protected’ on the back of the fan motor as these are all ways playing up in the summer months and giving temp problems
Re: hotpoint ff72s
ok guys this thing is getting on my t**s now.fitted new fan motor and both the thermistors,adjust door checked cable entrys door sear etc etc freezer now on -22 fridge plus 26 wont get could out all any ideas??????????
Re: hotpoint ff72s
tony
hi i got hotpint8596 which is getting me mad i think module is duff me be your migth have same fault . fridge is not getting cold
- You must be logged in to reply to this topic.