- This topic has 11 replies, 3 voices, and was last updated 5 years, 12 months ago by
.
-
Posts
-
Hi needing some help. Our dishwasher is filling up with water fine and also emptying fine. It seems to go thru the whole cycle as the when you open the door after it’s finished the tablet is at the bottom but it goes thru periods where you hear no noise and the spraying arms are in the same position as before (I don’t think they are spinning at all). Had changed the pressure switch as had a repair guy in and said it was that. It wasn’t. So if anyone can help would be hugely grateful. Thanks
how does it fill
does it fill up then drain and keep doing that ?
which pressure sw did you change as there are 2 of them ?could be a motor fault. There is a capacitor to start this motor it may be faulty
Dave
are you sure you fitted the switches the correct way round as they are different pressures
the black switch is nearer to the front
Dave
right if your sure they are the correct way round and the wiring is on the correct terminals
then confirm this
turn on and set programme, start programme
the machine then pumps for a while and starts to fillwhat happens then does it
A fill for a while then the pump starts and drains some water and stops again. the machine continue to fill and it happens again and againB fills for a while then everything goes quiet
C or something else
Dave
when it stop i assume if left it does not do anything else after that
if yes have the light on the panel changed in any way. The unit gvies fault codes by changes in the panle lights
Fault may be **
main wash motor is not starting if yes
could be a few reasons1 its ingested something like glass as Kai said in the above post
2 motor capacitor has failed. this start the motor without it it just hums
https://shop.ukwhitegoods.co.uk/cap03-washing-machine-dishwasher-3uf-capacitor3 jammed motor siezed bearing etc
4 The programmer is not turning it on
Dave
- You must be logged in to reply to this topic.