- This topic has 6 replies, 2 voices, and was last updated 5 years, 11 months ago by
.
-
Posts
-
Hygena extractor fan switch, Model number APM 2502
Hi,I’ve just taken delivery of a replacement fan switch for the above model, however the new circuit board only has soldering connections for eight wires, where as the original Hygena board has nine wires that need re-soldering. Comparing the old and the new board I believe it’s the black or the orange wire That doesn’t have a soldering position.
Does anyone out there know how these replacement boards are wired up.
I would be grateful for any advice thanks.would have to see decent print side photo’s of both board to see if its possible
Whats wrong with the old switch ?
Dave
Thanks for your reply. The old board was burnt out. Unfortunately I’m unable to upload any photos, the files are too big even at the smallest size. If I can get help , I’ll try again.
thanks.all you have to do is host them on another site. like google, dropbox etc then post a public link. i will need higher quality photos anyway to be able to see them properly
Dave
from that i would say its the wrong board. typed the number off the board into site shop and got
https://shop.ukwhitegoods.co.uk/08080278-cooker-hood-switch-module
does that look better
Dave
- You must be logged in to reply to this topic.