Install Whirlpool Dishwasher Air Break Cover

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Install Whirlpool Dishwasher Air Break Cover

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • July 27, 2020 at 2:20 pm #98083
    damobolton
    Participant

    Any help greatly appreciated.

    I inadvertently removed the air break cover to my whirlpool dishwasher (inside left wall of the dishwasher). Slight problem as it will not now reconnect as the connection thread inside the side of the DW seems to move around. Any ideas how i fix this?

    Model ADG 8410 FD / 8511 842 15011

    Thanks

    July 27, 2020 at 6:48 pm #470810
    electrofix
    Moderator

    you will have to remove the machine and access the side so you can hold the part in poistion while you screw the part back in

    Dave

    July 27, 2020 at 7:16 pm #470811
    damobolton
    Participant

    Brilliant……thank you.

    It appears i have a “F6” reading on the display which points to a clogged inlet filter. Not surprising as i had a blocked sink which is now fixed.

    If anyone can point me in the direction of where the inlet filter is i would greatly appreciate it.

    Thank you.

    July 27, 2020 at 7:42 pm #470812
    electrofix
    Moderator

    from what i can see fault displays 2 numbers

    F6 followed by E ???

    what is yours showing ?

    Dave

    July 30, 2020 at 3:26 pm #470813
    damobolton
    Participant

    Thanks…apologies for the delay….Fault numbers are F6 & E4

    Thank you

    July 30, 2020 at 7:16 pm #470814
    electrofix
    Moderator

    could well be just a flooded base

    Dave

    July 30, 2020 at 7:25 pm #470815
    damobolton
    Participant

    Great… thank you. Where would you locate the drip tray?

    July 30, 2020 at 7:44 pm #470816
    electrofix
    Moderator

    its the base of vthe machine that almost touches the floor
    take the cover off below the door and mop it out, Remember to unplug not just switch off

    Dave

    August 2, 2020 at 4:52 pm #470817
    damobolton
    Participant

    Worked a treat….all up and running.

    Thank you so much. 🙂

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.