- This topic has 15 replies, 6 voices, and was last updated 5 years, 2 months ago by
.
-
Posts
-
Hi brought the above as a bit of a project
Ive nothing on the display but every 4/5 minutes i get 3 beeps??
Anybody got a fix or ideas??Yes sir it is
Ive tried to upload an image of the pcb lol but im new to the forum and cant seem to keep it within the limitswashingmachinewoman wrote:Afraid not. You need to share your file and post the link to that file.
OK so ill try this
https://drive.google.com/file/d/1sfv…ew?usp=sharing
So that looks like its ok 9i hope)
The reason ive posted this image …i think this machine as i said i brought knowing it had some problems and i think some of the connections to the pbc might be in the wrong place
If you look closely at the drum you will see a connector with no wire…this cant be right as i think its a sensor
Im just hoping theres a tech out there thats had experience with this machine or someone as one and could maybe take a photo of just how it should be
I know we live in dreams 😎If you get an E03 error and, I presume that’s what it is as there’s no mention of an audible alarm, then it’s a water tank fault. What about it, no ideas given just that it has a problem al it says is, “Aqauswitch connector is disconnected” and that’s all there is.
K.
kwatt wrote:If you get an E03 error and, I presume that’s what it is as there’s no mention of an audible alarm, then it’s a water tank fault. What about it, no ideas given just that it has a problem al it says is, “Aqauswitch connector is disconnected” and that’s all there is.
K.
The error code is E00
I have now moved one of the wires as it appeared wrong to me, i now have no display and if the machine is left on every 3/4 minutes i get 3beepskwatt wrote:E00 is a comms error between the main board and interface at the front.
K.
AH! but what would the fix be?
Finding out why there’s a comms error and fixing it as, they do not explain the reason why, only what it is.
K.
Just an update guys
Ive still got this very expensive shelve lol
Just wondered if there were any wiring diagrams out thereas far as i know sharp tech info is very hard to get
if its a comms error might just be a bad connection on the link between the boards. try taking the connectors off and replace them to clean contacts
Dave
- You must be logged in to reply to this topic.