- This topic has 6 replies, 3 voices, and was last updated 5 years ago by
.
-
Posts
-
Hi all,
I have a Whirlpool WWDC9440 which is 6 years old. It keeps throwing up an F06 fault code and I am running out of ideas as to what is causing it. When the machine is empty the drum will turn and go through a program, but stick a sock in it and it stops. I have checked the bushes, they were only replaced last year, lots of meat on them. The belt seems fine. I have checked the continuity of the motor also seems fine. What else can I check? Where should I go from here? Is it just a knackered motor or control panel?
many thanks
RuthWould there be excess play in the pulley or what? It seemed ok when I had the belt on and off last week, but I was focused on the motor at that point. Its such an intermittent fault its driving me insane. I had it doing a small wash today no problems but then I did a slightly bigger one and it washed ok but didn’t spin argh!
iadom wrote: Definitely not the BUSHES. 😉
Lol you’re absolutely right, stupid auto correct, definitely not bushes! Although perhaps if there was a couple of privets or maybe a nice hydrangea in there I might have more luck fixing it!
put a large wash in with the lid off
watch the pulley
if pulley is moving but drum is not theres you answerDave
- You must be logged in to reply to this topic.