- This topic has 1 reply, 2 voices, and was last updated 4 years, 10 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I’ve searched here and anywhere else I can find to try to diagnose a fault with a Whirlpool WFE 2B19 UK. No matter which cycle we select it fills with a little of water, sits for a few minutes and then empties while the Power and Start lights flash, the 1st and 3rd light on the front are on but I haven’t been able to find anything that might say what the problem is. It also emits 2 short beeps x 10 times while these are on with about a minute between each set of beeps.
This error has come up before a few months ago but turning the dishwasher off and then on again reset it and ran a cycle fine. I wasn’t able to find a reason for it then either. Any suggestions or ideas what might be the cause of this?
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.