- This topic has 1 reply, 2 voices, and was last updated 20 years, 10 months ago by
.
-
Posts
-
I’ve been having an intermittent problem for a while now where the dishwasher does not fill with cold water. The only way to overcome this fault is to remove the cold fill hose, drain out any water in the hose then reconnect. This used to clear the fault and it would not happen again for a few months, recently however the time between faults has decreased so it is now happening 2 – 3 times a week. Ant idears what is the cause of this:?:
Re: Hotpoint Ultima DF32
The fill matrix under the left hand cover of the machine is becoming clogged up, as well as the transfer hose from the matrix to the sump. Water instead of running into the machine is being diverted into a side chamber which actuates the shut off on the water valve.
The problem gets more regular as the build up increases.
Power off if you’re going to investigate yourself. :plug:
Regards,
Penguin45.
- You must be logged in to reply to this topic.