- This topic has 22 replies, 4 voices, and was last updated 18 years, 4 months ago by
.
-
Posts
-
Re: Bosch WFO2866GB/01 No Hot Water!
with the machine switched off the ntc reads 4 ohms and the water heating element goes to zero.
Re: Bosch WFO2866GB/01 No Hot Water!
With no disrespect intended but are you sure have the multimeter set correctly for resistence reading?
Greg
Re: Bosch WFO2866GB/01 No Hot Water!
Steve:
Heater should read c.25ohms
NTC sensor should read 2-4kOhms at room temperatureTherefore, both components are non-functional.
Penguin45.
Re: Bosch WFO2866GB/01 No Hot Water!
Hi there, I have an old bosch washing machine in the garage to compare with, the ntc on the old one gives the same reading as the new one and the old water heater gives the same reading as the new one also. As i said earlier all parts are brand new from bosch. i think it may be something else. I have checked all the wires to the parts and back to the control panel and they are all fine
Re: Bosch WFO2866GB/01 No Hot Water!
Steve, please check this meter of yours…..
A 240v/60w bulb will read 960 ohms.
A 240v/100w bulb will read 576 ohms.Penguin45.
Re: Bosch WFO2866GB/01 No Hot Water!
going to have a go tomorrow, i have checked parts on a working bosch machine to compare to the one i am trying to fix, all the readings are exactly the same, original problem started with the water not heating up, i wonder if something else is causing the problem?
Re: Bosch WFO2866GB/01 No Hot Water!
steved20 wrote:i wonder if something else is causing the problem?
Your multimeter readings? 😉
- You must be logged in to reply to this topic.