Dear BSH-Man…..

Home › Forums › General Trade Forum › Dear BSH-Man…..

Viewing 3 posts - 16 through 18 (of 18 total)
1 2
  • Author
    Posts
  • May 30, 2005 at 11:31 pm #135639
    gegsy
    Participant

    Re: Dear BSH-Man…..

    Goatboy wrote:I keep going to Bosch washers (3-7 years old), where the interlock has blown and taken the brain with it!

    Does this sound familier to anyone else. I hope not, because I’ve sold hundreds of these Bosch, and I cover them with my own warranty.

    Luckily none of ‘mine’ have had this problem yet.

    Done BSH for 9 years never had module go because of interlock.
    Ive seen a few go short and blow fuse.

    Greg

    June 8, 2005 at 11:44 pm #135640
    jimbo2207
    Participant

    Re: Dear BSH-Man…..

    There’s a very similar fault on Hotpoint WMA’s, blown controller card, if you look at the wiring connections to the control board it seems that the interlock has fried the board ….. but it’s the motor, it’s always the motor (1604116). Nice to hear that wonderful, built like a brick khazi Bosch mess up too.

    June 13, 2005 at 2:22 pm #135641
    andy2
    Participant

    Re: Dear BSH-Man…..

    I have found this a fairly common problem on the WM series too – no Neutral supply on the interlock due to a narrow blown track on the PCB.

    Cause faulty interlock.

    Andy 🙂

  • Author
    Posts
Viewing 3 posts - 16 through 18 (of 18 total)
1 2
  • You must be logged in to reply to this topic.