assasukasse

Forum Replies Created

Viewing 5 posts - 16 through 20 (of 20 total)
  • Author
    Posts
  • in reply to: Bosch SMS4472GB sticking in the wash cycle #424946
    assasukasse
    Participant

    Re: Bosch SMS4472GB sticking in the wash cycle

    Hello
    I ran a cycle with the machine open today to check what could be the problem.
    Water fills fine and cycle starts (I started program 3)
    After program 4 machine empty water and refills
    Moments later detergent tablet is released and washing cycle starts.
    Machine heats water fine but program hangs just before the mid of the washing cycle
    At this point machine loops
    If I move program one tiny click forward then the machine completes everything by itself..
    Was wondering if temp sensor is dead and doesn’t say OK to continue cycle…
    I tried to short the thermostat but nothing happens…

    in reply to: Bosch SMS4472GB sticking in the wash cycle #424945
    assasukasse
    Participant

    Re: Bosch SMS4472GB sticking in the wash cycle

    Hi and thanks
    I inspected the wiring harness, its ok and not brittle.
    I changed a bit the curvature and put some padding to prevent heavy bending.
    No idea where is the safety inlet valve or the float microswitch, I did a try run and it appears to perform ok, i will keep an eye to figure out what is the problem..

    in reply to: Bosch SMS4472GB sticking in the wash cycle #424943
    assasukasse
    Participant

    Re: Bosch SMS4472GB sticking in the wash cycle

    yes the water is getting hot
    and it also dries the dishes fine (heats up quite a bit)

    in reply to: Bosch SMS4472GB sticking in the wash cycle #424941
    assasukasse
    Participant

    Re: Bosch SMS4472GB sticking in the wash cycle

    Yes the coil warms up fine…
    It stops when is loading the spring of the tablet release… like needing a bit of help

    in reply to: Bosch SMS4472GB sticking in the wash cycle #424939
    assasukasse
    Participant

    Re: Bosch SMS4472GB sticking in the wash cycle

    it sticks in the middle of the wash cycle..
    fills water fine, starts to wash and when it reaches the middle hangs there.
    There is no operation that is performed there (when I advance it nothing else happens, it just starts moving by itself again)

Viewing 5 posts - 16 through 20 (of 20 total)