Forum Replies Created
-
Posts
-
Re: ISE w288eco – Drum banging + Cycle doesn’t finish
Slight thread resurrection but hoping you can help out Mr Watt. Reason being it appears I mentioned a sporadic problem some time ago with the cycle not finishing and the pump running continuously at 1 minute to go.
Washing machine (ISE w288eco) will not spin on any cycle. It will rotate and agitate the washing but when it comes to the fast spin it just doesn’t. Very slow spin when it should be fast spinning. Always almost gets to the end and then gets stuck at 1 minute.
All this time you can hear the pump running trying to expel water. There is no water left in the machine as its been drained out ready for the spin. There are no blockages in the drain both on the machine and the waste pipe exiting the house.
If I enter service mode I can get the machine to spin at full speed so the motor seems fine. I can also get it to drain nice and quickly.
Its like the electronics are not letting the machine spin as it thinks the water hasn’t been fully drained out…really perplexing. I’d appreciate any pointers please before I get someone in. Happy to spend some cash in parts but also worried its terminal.
BTW I’ve stripped the drain motor and its working fine with nothing in the filter.
Re: ISE w288eco – Drum banging + Cycle doesn’t finish
Thanks for the speedy response..
Thats interesting. Its more of a side to side movement. From memory, there were two springs on the top (fore and aft) and these were in place when the machine was checked by the engineer previously. Is it a warranty issue if I take the top off and check or do I need to call in the engineer for this ?
The machine gets filled with a reasonable amount of washing… I wouldn’t say it ever gets overfilled to the point of being overloaded. The behaviour tends to occur when there are towels in the machine so the drum is unbalanced.
Its also not been tipped anywhere near 45 degrees living under the worktop.
