[seanmfc]

Re: hotpoint sdw80 dishwasher

i have checked for any blockage and found none put into a 1.33 cycle and the fault codes have come up again im now going to give up the ghost now on this

does anyone know where i can get a decent slimline washer for under £300

[seanmfc]

hotpoint sdw80

hi
i recently fixed the al10 code now i have a al05 pump code but when i turn the machine off it returns itself back on

any ideas

[seanmfc]

Re: hotpoint sdw80 dishwasher

right i left the dishwasher off for a few days as i thought athere was a bit of excess water that tripped the electrics

when turning the electric back on everything tripped out again can i have put any wires back wrong im thinking thr connector at the very bottom plate is round the wrong way

[seanmfc]

Re: hotpoint sdw80 dishwasher

i have fitted the part but after a few min working the electrics tripped out im hoping it was a bit of excess water so im going to leave it a few days

[seanmfc]

Re: hotpoint sdw80 dishwasher

thanks for your help

[seanmfc]

Re: hotpoint sdw80 dishwasher

i just did what you said and have a reading of 0.00

[seanmfc]

Re: hotpoint sdw80 dishwasher

i cant put a photo on here yhe multimeter is a rapitest and starts 2 v k ohms sign then 20 v k ohms sign then
200 v k ohms m a then 500v 2000 k ohms the button at the top is set to ohms and the dial is on 2 any other settings i dont get any reading

[seanmfc]

Re: hotpoint sdw80 dishwasher

ok do you test the 2 prongs to get a reading or do you have to use earth if its the 2 prongs i have a reading that was done on 2 setting 0.28 ohms

[seanmfc]

Re: service M6500

it looks like a bow tie

[seanmfc]

Re: hotpoint swd 80 slimline dishwasher

fitted the new heating element and all works fine the strange thing is my friend has done a reading on the old h/e and is getting a reading of 27.00 ohms my multimeater reads 0.03

thanks to all for their help

[seanmfc]

Re: hotpoint swd 80 slimline dishwasher

thanks i ordered it today it looks easy enough to replace i was thinking of putting jublie clips on to hold the hoses will they do

thanks

[seanmfc]

Re: hotpoint swd 80 slimline dishwasher

ok thanks will order a new haeting element and fingers crossed

[seanmfc]

Re: hotpoint swd 80 slimline dishwasher

ok just had a look the board is fine no scorch marks testing of the heating element showed a readin of 0.03 ohms no matter what way i put the prongs on
does this confirm the heating element is at fault

[seanmfc]

Re: hotpoint swd 80 slimline dishwasher

sorry im dyslesik lol

[seanmfc]

Re: hotpoint swd 80 slimline dishwasher

hi has anyone a picture of where the heating element is

thanks

[Author]

Posts