- This topic has 4 replies, 2 voices, and was last updated 3 years, 6 months ago by
.
-
Posts
-
Hi all,
My Beko DIS16R10 is refusing to start. There’s no water pooled in the bottom and I’ve rinsed the sensor below the filters in case it was that.
The switches are capacitive touch and I’m not certain the start/stop button is registering input.
The user manual allows for water hardening adjustment using a combination of keys + the start button and this won’t work, so perhaps it isn’t working.
I’ve tried holding it down for 3/7/10 seconds, unplugging for a minute, with no obvious reset taking place.
I’ve attached a video so you can see this happening.
If anyone knows what I should clean/replace it would be greatly appreciated. Thanks
[video]https://www.veed.io/view/dd84ff3b-21ed-4150-8f3d-1fd0194a4344?sharingWidget=true[/video]
you would have to strip it and see
it may not be touch buttons but small tactile switches
if you remove the panel and check. there seems to be an electronic panel underneath where the switches are
look for water damage, bad connections etc
Dave
They’re definitely touch on this model at least, PCB inside looks absolutely fine, it’s so tiny there’s no chance I can test the pins for the start switch to see if it’s registering.
I can’t imagine it’s an insanely expensive part but no website seems to just sell the buttons for this one.
if the panel has failed then looks like touch circuit comes with the top panel
got part no but no one has sold one anywhere
you can check the loom as its not uncommon to break wires as they leave the bottom of the door
Dave
- You must be logged in to reply to this topic.