Hotpoint NSWE742U WS

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint NSWE742U WS

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 11, 2022 at 3:26 pm #101244
    rocker
    Participant

    I removed a soak from the sump hose today..lent the machine back at an angle to access to sump hose..removed the pump and sump hose..removed the sock…refitted the hose and pump…turned on the machine to test…the pump keeps running ?? won’t stop until I turn the machine off..any advice please.
    checking it might be the pcb ? Its only a couple of years old..cheers John

    October 11, 2022 at 8:39 pm #483978
    electrofix
    Moderator

    try putting a few liters of water in the machine
    then select drain

    this can reset the pressure sw water levels

    Dave

    October 12, 2022 at 12:35 pm #483979
    rocker
    Participant

    Hi Dave..Did that, it then drains the water and spins..ends cycle and door releases…great…set up a new wash cycle same keeps pumping..?? John

    October 12, 2022 at 4:48 pm #483980
    electrofix
    Moderator

    rocker wrote:Hi Dave..Did that, it then drains the water and spins..ends cycle and door releases…great…set up a new wash cycle same keeps pumping..?? John

    assume the pump stopped at the end of the cycle which means the board can turn off the pump

    so I would think its either
    pressure sw or board software

    cant access Hotpoint tech anymore so cant check for known issues

    Dave

    October 12, 2022 at 6:21 pm #483981
    rocker
    Participant

    No problem landlord job..I expect new machine…thanks for your help..

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.