- This topic has 7 replies, 2 voices, and was last updated 3 years, 4 months ago by
.
-
Posts
-
Hi,
I try to steer clear of dishwashers, but this one is for a friends dad and I said I’d take a look.
I don’t have the model info, but they are saying that there is an error code showing I44, does anyone have any pointers as to what I should be looking for.Thanks
MervI4 codes are all about pressure sw
I41 is no signal from pressure sensor
could just be blocked, some early units had a mod to stop blocking
if you get model and pnc the I can send you the info
Dave
Sorry for the late reply on this one.
The pnc is 91153641800. The side chamber had a leak and it was also blocked. I replaced the chamber and also the pressure switch as I couldn’t get it to clear the fault. I checked for any further blockages but couldn’t find any. I ran it through a couple of rinses and also a quick 30 min cycle and all appeared fine.
I got a call this morning to say that it is showing I44 again.
Any pointers?Merv
SWERV wrote:Thanks.
Other than checking the wiring to the pressure switch, it could be a board fault.or the pressure switch
Dave
- You must be logged in to reply to this topic.