- This topic has 18 replies, 4 voices, and was last updated 3 years, 3 months ago by
.
-
Posts
-
I have been given a corona branded iarp back bar fridge but cannot work out how to change the settings as I do not have a manual. Husband has pressed a few buttons too many and it is not getting cold enough or cycling long enough. I cannot find a similar control unit and picture is too large to attach. Serial number is 16FE89031 control unit has up/down arrow lights on the left, central number display and dot light top right and enter arrow light lower right. Can anyone help?
A picture would help, you can upload a photo to one of the many hosting sites and then paste it here. The model number of the unit would be very helpful as well.
I think I know how to adjust but I just want to make sure 😀
Don
Hi thank you for your prompt reply. I have sent a link which should show you some photos.
electrofix wrote:try holding the bottom right button for a few secs then see if the up and down arrows work
Dave
Just what I was thinking 😀
Don
Tried that then pressed down arrow got c1, in, ul, t6, y8 then down to y4 by pressing down arrow. Pressing up arrow made all lights flash?
Have tried resetting as per instructions by pressing up and down arrows for 6 secs but has not had the desired result. Has thrown up a new set of combinations 🙁
Hi, I have found out it is an eliwell controller, but was custom made and discontinued so they can’t help. Can you advise me if I bought a similar eliwell control are they easy to swap and do they come pre set? Thank you.
An Eliwell ID cool/chill controller will do the job, they are rated for 240v supply feed, some older units are 12v supply, you can check yours on the rating label on your old controller, if you have a 12v one you will need to bypass the transformer and wire the new controller to the 240v input supply from the transformer, ID cool very easy to set up, normally comes with an instruction manual.
- You must be logged in to reply to this topic.