- This topic has 4 replies, 3 voices, and was last updated 3 years ago by
.
Viewing 5 posts - 1 through 5 (of 5 total)
-
Posts
-
You should have about 1 ohm on heater and front ntc when you measure it resistance will move high or low can’t remember full it this happens ntc will be fine more than likely to be pcb then
kaibart wrote:You should have about 1 ohm on heater and front ntc when you measure it resistance will move high or low can’t remember full it this happens ntc will be fine more than likely to be pcb then
1 ohm does sound a bit low
Dave
I mean 1 ohm across both stats on heater front ntc resistance will be different will be kohms up it will rise or fall I can’t remember
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.