Logik LCD8W22

Home › Forums › Public Support Forums › Help And Support › Tumble Dryer Help Forum › Logik LCD8W22

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • May 15, 2023 at 9:46 am #101958
    clint1974
    Participant

    Hello

    Tumble dryer starts for 10 seconds or so and then stops with 2 x flashing lights. Manual informs something to do with NTC ? Appreciate any advice.

    May 15, 2023 at 4:46 pm #486862
    electrofix
    Moderator

    an NTC is a temperature measuring device used to control the heat

    Dave

    May 16, 2023 at 7:47 am #486863
    clint1974
    Participant

    Thanks, do you know which one i need to change to rectify issue ?

    May 16, 2023 at 9:23 am #486864
    electrofix
    Moderator

    ok depends which lights are flashing

    look at pic below and let me know which ones

    Dave

    May 16, 2023 at 10:06 am #486865
    clint1974
    Participant

    3H & 9H both flash continuously

    May 16, 2023 at 9:14 pm #486866
    electrofix
    Moderator

    ok
    thats the ntc mounted on the heater

    so faults can be

    ntc faulty replace heater

    wiring broken between ntc and board

    board faulty

    the next step would be to locate the ntc and measure. it should measure 19.5 K ohms at 20 degrees C

    if it is out of spec you will need a new heater. this should be the one but you need to check with the shop, by sending in your serial no

    https://shop.ukwhitegoods.co.uk/32031612-tumble-dryer-heater-assembly


    Dave

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.