Hoover H3WS495TACE-80 (Ser 31010781 2113 0004) New module in Demo Mode

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover H3WS495TACE-80 (Ser 31010781 2113 0004) New module in Demo Mode

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 18, 2024 at 6:36 pm #102710
    hebegebe
    Participant

    If anyone has any advise to offer on this, I would be very please to receive it. I fitted a replacement control module (Part No. 49123457 – programmed). Display shows on power-up and allows programme selection, gives selected programme name and time, but also says ‘Demo Mode’ before the programme details. It refuses to start, and the door doesn’t lock – no flashing key symbol on the display. Have tried Spin & Soiled buttons for 7 seconds (and more) to no avail. Have I received a faulty module or has anyone else had this issue?
    T I A
    Graham

    April 18, 2024 at 8:28 pm #490129
    electrofix
    Moderator

    bit of a long shot

    sent you info on test routine see if it will do that

    Dave

    April 18, 2024 at 10:13 pm #490130
    hebegebe
    Participant

    Thank you Dave. Help much appreciated. I’ll give it a go tomorrow.
    Graham

    April 19, 2024 at 7:34 am #490131
    neilbow
    Participant

    Good Morning, emailed Gias tech services and they replied “The appliance is in demo mode, press and hold the spin and stain/rapid buttons at the same time for 7 seconds, this will remove it.”
    Regards Neil

    April 19, 2024 at 6:24 pm #490132
    hebegebe
    Participant

    Thanks Dave and Neil, Tried all known solutions today, but to no avail. Going to order another module and if that doesn’t work, it’s another perfectly good machine going to the tip. Graham

    April 20, 2024 at 9:40 pm #490133
    electrofix
    Moderator

    according to tech there are 3 modules fitted to this model dependant on serial

    from what i can see you should have part no 49122816

    have you got this one ?

    Dave

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.