f&p 708 burnt motor contoller

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › f&p 708 burnt motor contoller

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 19, 2005 at 7:04 am #11417
    grossy
    Participant

    Had no power to washing machine traced it to the motor controller burnt transistor ! Replaced board and suspect OOB switch. Done 2 more washes and the same thing happened same transistor burnt, attempting to replaced transistor and now run diognostic mode when I found out how.
    Has anyone heard of this and do you know how to run diognostic mode.

    Did display a code once with the beeps : led on short wash and the last 2 led’s on aswell


    Cheers Grossy 🙂

    August 19, 2005 at 7:17 pm #145299
    KiwiwantsworkinCanada
    Participant

    Re: f&p 708 burnt motor contoller

    There should hzve been a checlikst in the box with the board. Usual suspects are inlet valves 65 ohms, drain pump 32 ohms, motor 32 ohms across any 2 terminals, and lidswitch wiring rubbing on cabinet. Check these first.

    August 19, 2005 at 11:38 pm #145300
    grossy
    Participant

    Re: f&p 708 burnt motor contoller

    Cheers
    😆 I went straight for the lid wiring and bingo its been arching on the body. plan to still do diognostic if anyone can help, once i replace the transistor and wiring!!!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.