Hotpoint B/I double oven BD81, light coming on?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint B/I double oven BD81, light coming on?

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 23, 2005 at 11:10 am #12129
    Tubs
    Participant

    Hi all

    Have no wiring diagram for this model, (before I pull it all out)

    Can anyone confirm flo tube on display panel is suppose to light up when control panel cooling fan cuts in if oven gets too hot (after switching oven off) normally fan just runs for a period of time after. Not seen it bring flo tube on aswell. ❗

    Regards Steve

    September 23, 2005 at 12:39 pm #147999
    Seamy
    Participant

    Re: Hotpoint B/I double oven BD81, light coming on?

    Don’t think the fan should have anything to do with display, as far as i’m aware theres a t’stat on the top of the oven cavity that comes on when it detects heat & switches off fan after it has cooled down, the display lamp gets a feed through the selectors, whether oven, or grill is selected, so look towards at a faulty switch if it stays on??

    September 23, 2005 at 12:49 pm #148000
    Tubs
    Participant

    Re: Hotpoint B/I double oven BD81, light coming on?

    Hi seamy, my thoughts exactly. Does seem to imply that the selector switch has welded itself together on the selector switch side, so of course the light would come on anyway when the selector switch is turned. Must be getting a feed when toc cuts in when cavity gets too hot.

    If the light does come on with fan its the first ive ever seen. Looks like i have no choice but to pull it all out 😥

    Thanks Steve

    September 24, 2005 at 8:48 pm #148001
    bobokines
    Participant

    Re: Hotpoint B/I double oven BD81, light coming on?

    I believe the light comes on whenever ANY energy regulator is turned and stays on for a preset time determined by the module in the top cavity.

    Probably doesn’t help without a wiring diagram though.

    Bob

    September 25, 2005 at 5:59 pm #148002
    burns
    Participant

    Re: Hotpoint B/I double oven BD81, light coming on?

    I guess I would start with a fluorescent tube and replace the starter which is situated in the rear (near terminal block), usually the tube gets changed and becaues the starter is hidden it gets forgotten about.
    Possible choke could be faulty but these usually are very reliable.

    September 26, 2005 at 11:20 am #148003
    Tubs
    Participant

    Re: Hotpoint B/I double oven BD81, light coming on?

    Hi Guys

    Thanks for the input.

    Oven all works ok, light comes on when it should (when regulators are turned etc) just decides to fire up flo tube when cooling fan cuts in. As you know could be a couple of minutes after ovens are turned off. Unit appears not to have trigger board (partfinder Cd).

    Will post outcome, back there next week armed with selector switch ❗

    Steve

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.