wma 58s hotpoint wash

Home › Forums › Public Support Forums › Spare Parts Help › wma 58s hotpoint wash

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 29, 2005 at 10:21 am #12255
    drew1
    Participant

    MCB on distibution panel triped and traced problem to a hotpoint wma58s.
    strong smell of burning.
    on inspection found on main control pcb areas of track damage around selector switch and X1 connector. this connector runs to motor.

    the numbers on the pcb are on red sticker
    ako 547004-01 hw01
    gda 1617205608
    mask index 022

    70223.01 .04

    stamped on board
    0440612210


    it is a wma 58s
    26141813


    any ideas where I can get a replacement board?
    could the motor have caused this what is the best way to test motor

    thanks in advance

    September 29, 2005 at 10:36 am #148718
    iadom
    Moderator

    Re: wma 58s hotpoint wash

    If the machine is under five years old you are covered by your manufacturers parts warranty. The motor will more than likely have caused the module failure, can also be caused by wiring harness damage.

    Hotpoint will charge you just under £90 for labour only, far less than the cost of the parts required.

    Looking at that serial number, it is well under five years old.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.