- This topic has 1 reply, 2 voices, and was last updated 20 years, 6 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I’m assuming it’s a fault code 7 – it gives 7 flashes followed by a pause. Basically when I start the machine it enters the fault mode almost immediately. If I clean the filter and the spray arms it is usually okay.
MFI say it’s a water flow problem and is normally the water chamber needing replaced. I guess this could be a trick to get a technician out (my machine is over a year old).
Appreciate any advice.
Re: Diplomat ADP8322 – code 7
Yes, MFI are probably correct to be honest, it’s a flow meter problem E7 and the part is housed in the chamber.
Definitely one for an engineer, you shouldn’t have too much problem finding one, check Repairs@ and the directories on the main navigation menu 🙂
Dave.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.