WMA wire chafe

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › WMA wire chafe

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 17, 2005 at 8:15 pm #12642
    Simon46
    Participant

    Got a 35S with bared shorted motor wiring versus concrete block and blown board tracks. Is The motor wiring loom available as a spare part and is it usually replaced whole in this case. Or repairwise is the wiring to be joined at a non flexing point in the loom. What is the best way of tying it out of the way to prevent this happening again? This is my 2nd WMA repair after fobbing them off up till now to HPT.

    S.

    October 17, 2005 at 8:51 pm #150736
    Dave_Conway
    Participant

    Re: WMA wire chafe

    1603396 is the motor/door harness (loom) at about £3 😀

    Damn reasonable for a change.

    Dave.

    October 17, 2005 at 10:11 pm #150737
    bobokines
    Participant

    Re: WMA wire chafe

    These problems only appear AFTER a Hotperloni engineer(ha) has been at work on these machines. It looks like they need some training. 😉

    Bob

    October 18, 2005 at 6:06 am #150738
    Simon46
    Participant

    Re: WMA wire chafe

    It does look like there is a previously tied part in the loom due to a kink in the motor wiring where it has been hung from the drum. Thanks Dave/Bob.

    S.

    October 20, 2005 at 7:01 pm #150739
    burns
    Participant

    Re: WMA wire chafe

    As stated if the loom is tied up correctly it doesnt usually cause a problem, its after a drum change is when he problem arises.

    For good measure try some spiral wrap – rswww.com

    same for the washer dryer – cable wearing against cabinet behind timer.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.