Hotpoint WD71P W/DRY

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WD71P W/DRY

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 10, 2005 at 2:34 pm #13209
    DAR01
    Participant

    Switch on Display shows SET PROGRAM, unable to select program, stay on SET PROGRAM when program selection made.

    By passed door switch still same.

    No obvious damage to any of the boards, HELP !!!!!!!!

    Mike

    November 10, 2005 at 4:07 pm #153607
    Martin
    Participant

    Re: Hotpoint WD71P W/DRY

    DAR01 wrote:No obvious damage to any of the boards, HELP

    Mike,

    Do double check the state of the boards for damages especially from water leaks from the door seal or holed front drum plate. Check the water heater and motor? If all checks out OK, send both modules (Power & Programme) to Tony at EMW for him to test:-
    http://emwelec.co.uk/

    Finally, always, but always, replace the Interlock whenever you have need to repair or replace a module (they’re cheap to replace yet cause so much grief in you don’t 😉 )

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.