hotpoint wma11

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wma11

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 1, 2005 at 12:46 am #13724
    hilly
    Participant

    i replaced carbons about a week ago and customer called me back because on a long wash it smelt of burning ive checked everything all ok then i cleaned the com just incase now all the machine will do is drain for about a minuite. it wont reset, ive checked all components and connections. any ideas?


    thanks paul

    December 1, 2005 at 7:51 am #156300
    Phidom
    Participant

    Re: hotpoint wma11

    Chafed wiring loom? Motor TOC?

    December 1, 2005 at 1:34 pm #156301
    nigegt
    Participant

    Re: hotpoint wma11

    Hi paul

    Have come across similar problem after brush change, appliance failed again after about a week with burning smell and it had blown some tracking on the control pcb where the motor connector is. It appears it was allmost burnt out when the brushes where worn and managed to work for a week after before packing up alltogether!, re soldered and all ok no come back but always check for it now as a very annoying recall!!

    Nige

    December 3, 2005 at 12:55 pm #156302
    technics1200
    Participant

    Re: hotpoint wma11

    I used to WD-40 the Comm, clean it up, wait for dry then change brushes.

    Slow but works 😥

    December 9, 2005 at 9:14 am #156303
    hilly
    Participant

    Re: hotpoint wma11

    thanks for advice found out it was a motor fault


    thanks paul

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.