Candy SP120TR (37616398 ) No spin

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Candy SP120TR (37616398 ) No spin

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • December 2, 2005 at 2:04 pm #13763
    geoffmackay
    Participant

    HELP!

    Machine has module checked, motor replaced, pressure switch replaced, and the Timer replaced, but still refuses to spin.
    Machine will agitate with water in , pumps out ok, and goes into distribute as it is ramping up the machine shuts down.

    Any Ideas?

    December 2, 2005 at 5:02 pm #156500
    Dave_Conway
    Participant

    Re: Candy SP120TR (37616398 ) No spin

    It can’t be anything but the module can it if all the rest has been replaced ?

    Although, check the user option buttons (I know it’s obvious ;)) but with the wrong combination these won’t spin.

    Dave.

    December 2, 2005 at 6:30 pm #156501
    leavemetogetonwithit
    Participant

    Re: Candy SP120TR (37616398 ) No spin

    geoffmackay wrote:as it is ramping up the machine shuts down.

    What, even stops pumping?

    December 2, 2005 at 9:49 pm #156502
    geoffmackay
    Participant

    Re: Candy SP120TR (37616398 ) No spin

    Yes, with a full load in the drum the machine shuts down. Had the module checked by QER and stood next to technican, witnessed it spinning ok thats whats so unusual.

    December 2, 2005 at 11:11 pm #156503
    Martin114
    Participant

    Re: Candy SP120TR (37616398 ) No spin

    I remember years ago on at least two occasions when the servis quartz was ramping up to spin, the program just cleanly reset with no fault code indicated.It turned out on these occasions to be the RF suppressor at fault. It was not filtering the noise from the brushes and the board was influenced by this unwanted input!

    December 2, 2005 at 11:40 pm #156504
    whiskeyjack6058
    Participant

    Re: Candy SP120TR (37616398 ) No spin

    Is the heater down to earth?

    December 2, 2005 at 11:51 pm #156505
    Penguin45
    Participant

    Re: Candy SP120TR (37616398 ) No spin

    I’m with Martin114 – mains suppressor. Had this a few times, no obvious reasons but swapping it out did the trick.

    Chris.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.