smartdrive 051 short pulses of water soleniods,wont agitat

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › smartdrive 051 short pulses of water soleniods,wont agitat

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 20, 2005 at 9:26 am #14174
    Nath
    Participant

    I had a leaking seal and bad top bearing which caused the rotor position sensor to arc to the winding core. I repaired the sensor board and coated it with araldite to protect it, which worked for a load and a half.
    Now it wouldnt start and water solenoids just pulse a few times and then it cuts out. error code seems to be 131 which I gather is the sensor board.
    Is there a way to test this board before I buy a new one ?Or maybe prove it isnt the main board ? I have replaced the bearings and seal so should be no more water around….

    Thanks
    nathan nathanspargo@slingshot.co.nz

    December 20, 2005 at 9:18 pm #158455
    Penguin45
    Participant

    Re: smartdrive 051 short pulses of water soleniods,wont agit

    131 is specifically a motor position sensor failure. It can be just wiring, or motor controller board. Sensor is p/no 425221P and is probably the place to start.

    Regards,
    Penguin45.

    December 21, 2005 at 7:28 am #158456
    Nath
    Participant

    Re: smartdrive 051 short pulses of water soleniods,wont agit

    I got a used rotor position sensor from the rubbish dump recycling plant for $5 and its working ok now.With the new bearings in as well I can talk while its spinning which is new ! Thanks for your help with this.
    I apreciate it…….

    Cheers

    nathan

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.