aeg waasher dryer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › aeg waasher dryer

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • December 21, 2005 at 11:22 am #14213
    mike1
    Participant

    model L16810 prod 914601605 can anyone help with a problem on the above it washes ok and spins ok but wont dry theres no power to the element or the fan however the drum rotates as it should to dry! I think it could be a pcb fault does any one have expierience of this ?

    December 21, 2005 at 12:15 pm #158628
    Dave_Conway
    Participant

    Re: aeg waasher dryer

    No error codes would indicate a faulty PCB.

    If you’re on broadband, I can send a hefty (5mb) config/test PDF if it will help ?

    Dave.

    December 21, 2005 at 12:31 pm #158629
    Martin
    Participant

    Re: aeg waasher dryer

    Go for the obvious Mike before fretting over the Module (last place to look actually 😉 )

    Valve open circuit? Overheat stat? NTC open circuit or earth fault on it? Trace the wiring back to source?…all good fun 🙂

    December 21, 2005 at 12:35 pm #158630
    mike1
    Participant

    Re: aeg waasher dryer

    Thanks Dave I have sent you a P.M.

    Mike

    December 21, 2005 at 12:42 pm #158631
    Dave_Conway
    Participant

    Re: aeg waasher dryer

    On the way 😀

    Sorry, I didn’t word the first line of my reply very well and didn’t finish it correctly.

    Martin has done it for me though :tup:

    Dave.

    December 22, 2005 at 9:01 pm #158632
    Flyman
    Participant

    Re: aeg waasher dryer

    Fan does not come on until the element has heated to a certain temperature so ignore the fan and concentrate on the power to the element problem. Check diagnostics for an error code.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.