F&P MW051-U Diag procedure and fault codes please.

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › F&P MW051-U Diag procedure and fault codes please.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 26, 2005 at 5:04 pm #14302
    thewizardoz
    Participant

    I’ve got a F&P MW051-U which lights OK when switched on but does not run, i.e. in pressing “Start’ the drum jerks once then nothing more.

    When I go into diag mode I am not certain that I am using the correct procedure for this model – I am using 601 procedure and codes.

    So I would appreciate the correct diag procedure and fault codes please.

    Thanks.
    Mark

    December 28, 2005 at 7:03 pm #158931
    Penguin45
    Participant

    Re: F&P MW051-U Diag procedure and fault codes please.

    To enter Diagnostics:
    Power on at socket, off on machine. Press and hold “Wash Temp Down”, then “Power”. Yours is a phase 2 machine, so press “Advance” once. From there, use the spin buttons until “Hold” and “Slow spin” leds are lit. The pattern of lights on the wash progress board will now indicate any fault in binary code, from right to left.

    Regards,
    Penguin45.

    December 29, 2005 at 1:28 am #158932
    thewizardoz
    Participant

    Re: F&P MW051-U Diag procedure and fault codes please.

    Thanks Penguin45, I’ll give it a try.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.