Blomberg WA1300 – Won’t flush powder or start rinse cycles

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Blomberg WA1300 – Won’t flush powder or start rinse cycles

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 9, 2006 at 6:46 pm #14660
    Dickie
    Participant

    I’m no expert but it sounds like the cold water may not be getting through?

    If I manually flush the powder it continues (with water from the hot feed I presume) until it gets to a rinse cycle and then it stops. Perhaps a cold inlet valve or some sort of solenoid not working?

    This is an old machine and we’ve had excellent service from it, however, I don’t want to bin it if it’s a ‘simple’ replacement part of some sort.

    Anyone got any ideas?

    Also, if anyone knows part numbers and where to get the part(s) this would be really helpful.

    Cheers,

    Richard.

    😥

    January 9, 2006 at 9:14 pm #160361
    Penguin45
    Participant

    Re: Blomberg WA1300 – Won’t flush powder or start rinse cycl

    That’s the old Ocean-built Blomberg, IIRC. One of these:
    http://www.ukwhitegoods.co.uk/modules.p … cts_id=415
    should do the trick.

    Always assuming that the cold supply is on…….. Those little blue tags wear and don’t always turn the water on. 😀

    Power off if doing this yourself.

    Regards,
    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.