Hotpoint TD T620CW No Heat

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint TD T620CW No Heat

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • January 10, 2006 at 2:48 pm #14681
    laurenceuk
    Participant

    Hi,

    Can someone confirm that the start relay also brings in the heater (or not). I have no wiring diagram.

    The cut outs and heater are fine. Float microswitch sump empty. I trace the leads back to the relay so am assuming that this controls the heater cct also.

    Is the relay a known potential `no heat` fault or is ti the timer?

    Thanks

    Laurence

    January 10, 2006 at 3:11 pm #160443
    Dave_Conway
    Participant

    Re: Hotpoint TD T620CW No Heat

    It won’t be the relay 😉

    Either the thermostat in the front bearing housing/door area or possibly the timer.

    Dave.

    January 10, 2006 at 3:23 pm #160444
    Martin
    Participant

    Re: Hotpoint TD T620CW No Heat

    Lets clear one thing up first, I think we are talking Creda here and not Hotpoint (Creda T620CW) :tup:

    The fault more than certain is NOT the Relay in this case but the Timer (1702509) as the heat switch terminal burns out on these beasts more often as not 😉

    The only fault the Relay can give you is not starting or starts up then stops after a minute or two.

    January 10, 2006 at 3:24 pm #160445
    Martin
    Participant

    Re: Hotpoint TD T620CW No Heat

    :wave: Hows it going Dave :wave:

    January 10, 2006 at 3:46 pm #160446
    Dave_Conway
    Participant

    Re: Hotpoint TD T620CW No Heat

    :wave:

    😀

    January 10, 2006 at 3:49 pm #160447
    laurenceuk
    Participant

    Re: Hotpoint TD T620CW No Heat

    Thanks Martin/Dave,

    You are quite right, it is a Creda – brain to finger trouble 😳 .

    Thanks for the insight.

    Laurence

    January 10, 2006 at 3:53 pm #160448
    Martin
    Participant

    Re: Hotpoint TD T620CW No Heat

    laurenceuk wrote:Thanks for the insight.

    Our pleasure Laurence, now take a nap and rest a spell 😆

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.