Bosch WF02864

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Bosch WF02864

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • January 22, 2006 at 8:48 pm #15038
    jemtee
    Participant

    Replaced brushes on machine and worked great for about 20 washes. Now when it reaches spin cycle – 11minutes on display – it works till 9 mins then jumps to 1 minutes and ends. It has not spun out. Any ideas please

    Janet

    January 22, 2006 at 9:36 pm #161768
    superfix
    Participant

    Re: Bosch WF02864

    Does it pump out the water?.

    Are there any lights flashing on the fascia?.

    January 23, 2006 at 8:53 am #161769
    jemtee
    Participant

    Re: Bosch WF02864

    It pumps out the water and there are no lights flashing on the fascia

    Thanks

    Janet

    January 23, 2006 at 8:55 am #161770
    Martin
    Participant

    Re: Bosch WF02864

    One of the brushes most likely has overheated and is sticking in its housing 😉

    January 23, 2006 at 9:00 am #161771
    jemtee
    Participant

    Re: Bosch WF02864

    took out the brushes last night to check in case they were sticking, replaced them and still the same result with the spinning

    Thanks

    Janet

    January 23, 2006 at 9:08 am #161772
    Martin
    Participant

    Re: Bosch WF02864

    Is the motor turning at all?

    January 23, 2006 at 9:13 am #161773
    jemtee
    Participant

    Re: Bosch WF02864

    Hi

    The machine runs fine with the drum turning etc right up to this point.

    Thanks

    Janet

    January 23, 2006 at 9:26 am #161774
    Goatboy
    Participant

    Re: Bosch WF02864

    Did you buy genuine Bosch brushes? 😕

    January 23, 2006 at 11:54 am #161775
    jemtee
    Participant

    Re: Bosch WF02864

    I bought the brushes from UK white goods but they are probably not genuine spares

    Janet

    January 23, 2006 at 12:09 pm #161776
    Goatboy
    Participant

    Re: Bosch WF02864

    :eeek:

    When an qualified engineer changes the brushes, he/she will do a few things to make sure those brushes last; like, cleaning the armature, and cleaning the carbon disposits off the PCB, especially the little heat-sink, as this could cause a short circuit on the PCB, and lead to a dodgy motor as you describe 🙁

    January 26, 2006 at 10:47 am #161777
    jemtee
    Participant

    Re: Bosch WF02864

    Hi seems to be ok now thanks a lot

  • Author
    Posts
Viewing 11 posts - 1 through 11 (of 11 total)
  • You must be logged in to reply to this topic.