- This topic has 4 replies, 5 voices, and was last updated 20 years, 1 month ago by
.
-
Posts
-
hi guys,
hpt WMA40 .
customer phoned,says the machine is dead,tries to select program but “door locked” light keeps flashing.she said that she has had to bang the door to get it to work for the last 2 weeks.
sounds like door interlock.
went out this morning and fitted interlock,no difference.cable from interlock to control pcb is ok,no obvious burn marks or tracks damaged on control pcb.
any suggestions?
there is power getting to the interlock.
do you think control pcb is to blame?
johnRe: hpt WMA40 door lock
Had same problem month or so ago, replaced control module behind facia to clear problem.
Dave TRe: hpt WMA40 door lock
always worth tilting machine back and check wiring harness as it comes up the front panel next to front weight ihave had loads with broken wiring due to rubbing against the corncrete Cliff .N 8)
Re: hpt WMA40 door lock
Have a look at the small chip, at the bottom, right hand corner of the module, looking from the green track side. Sometimes you will be able to signs of damage., often caused by the door interlock.
- You must be logged in to reply to this topic.