- This topic has 5 replies, 4 voices, and was last updated 20 years ago by
.
-
Posts
-
Anyone have any ideas on this little problem, the machine tries to spin on wash or rinse. We have tried a new motor, power module but the problem continues. There’s not much else in this machine other than the selector has anyone got any ideas. 🙂
Re: Arsiton A1436
Is it going into full spin? These machines do have a fast tumble on some programmes which looks very wrong the first time you see it and it may well just be that rather than a fault, if not check for earth leakage on the heater maybe?
Nige
Re: Arsiton A1436
Hi Nige
I will double check the Insulation on the element and have another look at the spinning.
Ta
Re: Arsiton A1436
May be linked to this
Are you sure it is spinning on the ‘wash’ section of the rinse cycle?Re: Arsiton A1436
Hi,
I have had further chance to spend with the machine and by having an opportunity to plug the Merloni Test Module into the diagnostic port F02 was appearing as well as F07. Motor tacho was indicated as well as NTC/ Heater malfunction. Have tried a new motor, did not cure problem, have reflashed the PCB Eprom and recoded, Then showing FO3 !
Have fitted new PCB and reprogrammed PCB and still faulty, turns out the wiring harness between module and motor/heater has breaks in it causing all manner of error codes as above. Awaiting new harness which shopuld be the end to this one. It transpires that Merloni have a service sheet on this very problem. 8)
- You must be logged in to reply to this topic.