Bosch WTA3204GB/09

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch WTA3204GB/09

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • March 21, 2006 at 8:32 am #16531
    ChrisR
    Participant

    What`s the normal reason for a `no heat ` fault on this drier?

    Heater checks out ok along with TOC.drier runs ok but no heat or very little.
    Suspect sensor above heater elements???.

    Thanks.

    Chris.

    March 21, 2006 at 9:47 am #170253
    Beever
    Participant

    Re: Bosch WTA3204GB/09

    Check the heater ntc on the heater

    March 21, 2006 at 5:51 pm #170254
    ChrisR
    Participant

    Re: Bosch WTA3204GB/09

    Thanks very much Beever……..I`ll try that. 😀

    March 21, 2006 at 6:23 pm #170255
    ChrisR
    Participant

    Re: Bosch WTA3204GB/09

    Hi Beever.

    Theres no black housing and no green stat that I can see.

    Theres a probe situated in the front ducting and that checks out ok.

    Any ideas?.

    March 21, 2006 at 7:56 pm #170256
    Penguin45
    Participant

    Re: Bosch WTA3204GB/09

    There is a safety cut-out on top of the heater box which can trip. Every one of these I’ve ever been to has ended up being the computer board………

    Chris.

    March 24, 2006 at 9:50 am #170257
    Beever
    Participant

    Re: Bosch WTA3204GB/09

    this appliance is an auto sensing one. if there is no wet load in the appliance, it will switch off within aprox 2 mins. It passes a current through the laundry, this charge is then picked up between the tank and the paddles, the drum and the paddles can get coated with a coating of softener, give the tub and paddles a clean to ensure that the charge is being detected.

    March 24, 2006 at 12:08 pm #170258
    ChrisR
    Participant

    Re: Bosch WTA3204GB/09

    Thanks guys for the help.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.