Servis M3101A W/M Not spinning

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Servis M3101A W/M Not spinning

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 22, 2006 at 9:19 pm #16582
    Fairdeal
    Participant

    Hi Guys,

    Went to se this job today.It takes water in then it does not spin at all.If I put on Spin programme, it drains the water out and spins slowly for a short while then it stops again.Checked the pcb nothing is blown but i still suspect it.
    Any ideas?

    Thanks

    March 22, 2006 at 10:13 pm #170557
    leavemetogetonwithit
    Participant

    Re: Servis M3101A W/M Not spinning

    Have you checked module very carefully for dry joints around relays?
    Mike

    March 23, 2006 at 10:42 am #170558
    Fairdeal
    Participant

    Re: Servis M3101A W/M Not spinning

    Yes there are no dry joints on the module.The only thing that i noticed was that the two white relays were hot.
    any idea?

    March 23, 2006 at 11:16 am #170559
    robbra
    Participant

    Re: Servis M3101A W/M Not spinning

    Hi,
    they should be hot but a lot of these modules can try and send the motor both ways on spin and so slow and then try again to spin. After many years on these machines the module is always first port of call.I have heard that an earth leak on the element can cause this but never come across it
    Rob

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.