- This topic has 2 replies, 2 voices, and was last updated 20 years ago by
.
-
Posts
-
Enr SGS43A32GB/01 FD 8206 550131
Initial complaint was that machine was sticking on cycle.
Checked heater, module for bad contacts, door loom etc. was a bit pushed for time so left the machine on rinse only cycle and asked the customer to report back, thinking that if it stuck on this then I was not looking a a heat related fault.
Customer has just rung back to say that not only did it complete the quick rinse cycle, but it has since done a full wash programme perfectly.
I wish I could market whatever it is that makes machines work perfectly as soon as I pass my hands over them 🙂 .
Could I have cleared a fault that is likely to return by tilting the machine over. base was bone dry BTW.
PS. how does the top of the mushroom come off?
Re: Bosch SGS43A D/W sticking.?
Initial complaint was that machine was sticking on cycle
Probably fill float sticking thus constantly fill/empty on the mushroom.
Replace pcb with revised logic and new safety system (mushroom).PS. how does the top of the mushroom come off?
It doesn’t, whole assy must be removed. Take base off, cut ball off bottom of mushroom stem, then snap stem above barbs, remove from inside tank.
P.S. a blob of grease helps hold the polystyrene float in place when refitting base 😉
- You must be logged in to reply to this topic.