- This topic has 8 replies, 5 voices, and was last updated 20 years ago by
.
-
Posts
-
hi m/c starts then stops replaced door s/w, went ok for a while and stops every few seconds push start and it goes again 😕 thanks Barryfast
Re: Hotpoint wmt 02
ncas wrote:try relay behind fascia
❓ WMT 02 is a washing machine, not a tumble dryer.
barryfast, I can send you the diagnostics if you would like them.
Jim.
Re: Hotpoint wmt 02
let me know how you get on with that relay i got one of those to do as well
although i just thought it would be on/off switch pushed in and stuck i seen that before a few times makes machine resetRe: Hotpoint wmt 02
This machine does not have a ‘separate’ relay. It is not a tumble dryer. The relays in this machine are components on the control module.
It does however have a separate start switch.
Re: Hotpoint wmt 02
Hi there i have had this problem does machine fill and cut out when motor starts if so possible broken tacho wires in harness close to a cable tie you may need to trace back from motor and give them a tug as will not be obvious. hope this helps.
Re: Hotpoint wmt 02
iadom thanks for your help in the end it was the board and thanks to EMW the m/c is now running so the board was the culprit replaced the carbons and door s/w as recomended Barryfast 😆
- You must be logged in to reply to this topic.