Creda easy load condensair dryer – advice needed

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Creda easy load condensair dryer – advice needed

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 30, 2006 at 1:01 pm #16787
    shellbeech
    Participant

    I have had the above dryer for 6 years and it has started to flash up after 15/20 minutes “empty water”. Each time I try to empty the water the butt is empty. The light then goes off and the cycle begins again for another 15/20 minutes. Unfortunately it means i have to start and stop the drying cycle to get get my clothes dry!!

    Anyone else experienced this and if so how did you solve it.

    Thanks
    😉

    March 30, 2006 at 2:51 pm #171519
    Dave_Conway
    Participant

    Re: Creda easy load condensair dryer – advice needed

    It’s probably got a sticky float switch but we’ll need the model number please to help further 🙂

    Dave.

    March 31, 2006 at 7:05 am #171520
    bobokines
    Participant

    Re: Creda easy load condensair dryer – advice needed

    This can simply be that breather hole in the condensate bottle lid is blocked. The breather hole allows the air to escape from the bottle whilst it fills via the valve from the back. Without a breather hole, the bottle will only fill with a very small amount of water.

    Check that you can see light through the hole, if not clean it out with a sharp pin.

    Bob

    March 31, 2006 at 7:40 am #171521
    shellbeech
    Participant

    Re: Creda easy load condensair dryer – advice needed

    Thanks,

    the model number is 37754.

    March 31, 2006 at 7:56 am #171522
    Martin
    Participant

    Re: Creda easy load condensair dryer – advice needed

    I’ll go along with Bob on that but possible suggest better still that someone strip and clean out the float chamber. It’s had 6 years of crud and needs cleaning out by now I expect.

    Try the link below for professional help on that score 😉

    April 3, 2006 at 1:46 pm #171523
    shellbeech
    Participant

    Re: Creda easy load condensair dryer – advice needed

    Thanks for the advice. The float chamber was cleaned out and it is tumbling away merrily!!

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.