- This topic has 5 replies, 3 voices, and was last updated 19 years, 12 months ago by
.
-
Posts
-
the above m/c will not start on a prog, when drain selected, it does a pulse drain then stops, (it does this at start of all other selected prog’s).
it then starts to advance a few pulse’s, pause’s, then starts to advance again till it eventually drains then stops, when this is done, it keeps advancing??. set onto a spin prog, again it pulse drains momentarily, then starts to fill?, washes then starts the advancing sequence again, till it eventually stops ,and drains,Phew!!.
anybody out there can help please,
thanks TELL..Re: Whirlpool AWM049/3 fast advacing??.
These programme timers often have a ‘skipping fit’ when the whole circuit is interrupted. (i.e. blocked air chamber, chafed wiring harness, low insulation on heater etc)
Re: Whirlpool AWM049/3 fast advacing??.
most probaly a motor fault…had this one recently,fitted everything bar the kitchen sink.???>>>called a mate who works with W/P…who had great joy in telling me it didnt need all the parts i had fitted,it just needed the motor..
still it was fun…notRe: Whirlpool AWM049/3 fast advacing??.
i have checked heater, and motor resistance etc, they seem to be normal readings i would expect. the carbon brushes were ok. and the level of water ok. the motor does tumble, but the programmer does not give it a chance to do anything else.
TELL..Re: Whirlpool AWM049/3 fast advacing??.
TELL wrote:its a whirlpool AWM049/3 fast advancing. wont start on a selected prog, or spin etc. the motor does tumble, the m/c does drain eventually, after it has advanced through progs a couple of times. any idea’s?
thanks TELL..I’ve just added your post to the original thread Tell, keeps it ‘neat & tidy to stick to one thread please 🙂
Incidentally, have you checked the heater on it?
Martin
- You must be logged in to reply to this topic.