indesit W161

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › indesit W161

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 20, 2006 at 11:48 am #17936
    geuzer
    Participant

    😕 😕 🙁 😮 😆
    Indesit W161 when out on a programme will fill with water and instead of slowly turn the clothes it goes into a spin and then the dial just clicks round / any ideas anyone

    May 20, 2006 at 11:50 am #177103
    gegsy
    Participant

    Re: indesit W161

    Module, tacho on motor fault or wiring to motor damage.

    Greg

    May 20, 2006 at 4:14 pm #177104
    geuzer
    Participant

    Re: indesit W161

    gegsy wrote:Module, tacho on motor fault or wiring to motor damage.

    Greg 😆 🙄 what do i do then , where is module located , do i change the motor ?

    May 20, 2006 at 5:10 pm #177105
    gegsy
    Participant

    Re: indesit W161

    Check the wiring form module to motor plug for continuity.
    Check the rear of the motor (opp motor shaft) to see if the small tacho unit is loose or hanging off.

    All these can be done with the power off :plug:
    Any further faulting would best sorted or confirmed by an engineer from the link below.
    Greg

    May 20, 2006 at 5:54 pm #177106
    iadom
    Moderator

    Re: indesit W161

    Also count the number of flashes on the mains neon when the knob starts to click round, it should click a set number then pause, then repeat this ubtil you stop it.
    The number of flashes is an error code.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.