Zanuusi DA6152 Dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanuusi DA6152 Dishwasher

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • May 28, 2006 at 10:48 am #18115
    Robbiebegg
    Participant

    Hi
    I have been out to above dishwasher not heating, I have checked heating element and it is okay. If I connect meter to wiring get 240volt when element cycle comes on but when I connect element it does not work.I have tried new element but still no joy.

    May 28, 2006 at 6:41 pm #177748
    iadom
    Moderator

    Re: Zanuusi DA6152 Dishwasher

    Have you checked the control module for dry joints, very common on heater relay, a blob of solder or a bridge link usually does the trick.

    May 28, 2006 at 6:53 pm #177749
    Penguin45
    Participant

    Re: Zanuusi DA6152 Dishwasher

    This one goes “Tick Tock”…….. :rotfl:

    Isn’t there an integral safety on top of the heater tube?

    Chris.

    May 28, 2006 at 7:15 pm #177750
    iadom
    Moderator

    Re: Zanuusi DA6152 Dishwasher

    Been a long hard day, 😳

    May 29, 2006 at 10:01 am #177751
    gegsy
    Participant

    Re: Zanuusi DA6152 Dishwasher

    iadom wrote:……… long hard 😳

    😯 Might be worth checking door switch, seen a few on meltdown. It maybe fine on low current, but just can’t deliver heater demand current.

    Greg

    May 29, 2006 at 11:57 am #177752
    Robbiebegg
    Participant

    Re: Zanuusi DA6152 Dishwasher

    Thanks for quick reply guys, will give these a go .I have just joined UKW so hope to help out all I can.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.