- This topic has 4 replies, 4 voices, and was last updated 19 years, 10 months ago by
.
-
Posts
-
any good advice for fitting these bl###y seals 😥 theres no room to get fingers in,especially where the spring goes behind the hotair inlet ❓ tried for an hour this afternoon,any help appreciated
Re: any tips on fitting zanussi w/dry door seals?
http://www.ukwhitegoods.co.uk/modules.p … ight=aargh
try this link
Bob
Re: any tips on fitting zanussi w/dry door seals?
Take the lid off. undo the single screw on top of the heater duct and the one ont the front panel, the ‘hot air inlet’ can be lifted up and out of the way. fit the seal as above then re fit the air intake. and the jetsystem hose if fitted. not easy but not that tricky either.
Re: any tips on fitting zanussi w/dry door seals?
no easy answer to problem apart from charging extra for the hassle.
i take door off, pull appliance forward and then tip back> this gives you much needed working access,once seal on>>use mole grips to secure retainer spring.
idea fold seal back at bottom >offer spring to bottom of seal then clamp with moles. thus allowing you two free hands to work spring into position..
cheers ally.
- You must be logged in to reply to this topic.