- This topic has 6 replies, 4 voices, and was last updated 19 years, 10 months ago by
.
-
Posts
-
bosch wvf2402gb/01 dryer heater failed I replaced ok but customer says machine is over heating (dangerous !) I see a “tunnel kit” part no 480948 is listed with stats etc is this designed to sort out this problem? is this a common fault? I know someone out there will know! 😉
wilf
Re: bosch washer dryer
Did you have to uncouple the water supply when you did the repair previously?
Im wondering if the hot and cold pipes have been put on the wrong way round. Worth checking first.Power off first :plug:
Greg
Re: bosch washer dryer
I believe these machines are cold fill only?
The Tunnel plate kit is a costly option and it’s cheaper just to replace each individual stat. 😉
However I think your problem is likely that bloomin’ condenser unit is clogged up. (a sod to get at too 🙁 )
Re: bosch washer dryer
Martin wrote:I believe these machines are cold fill only?
Yes you are right Martin 😛
Martin wrote:However I think your problem is likely that bloomin’ condenser unit is clogged up
If that were the case the safety TOC would activate.
I think thermostat replacement would be an avenue then to pursue.The thermostats are p/nos – 151455,172288 and 172287.
Greg
Re: bosch washer dryer
fan was running ok I usually trip the door switch to check the air flow but didnt on this one as two toddlers were getting the way and “safety first ” going back tomorrow will keep you posted
thanks wilf
Re: bosch washer dryer
I have NEVER had to replace a stat on one of these. As Gegsy says TOC would trip if appliance overheated.
Probably customer fault rather than m/c. 😆
- You must be logged in to reply to this topic.