Diplomat ADP 8322 Dishwasher

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP 8322 Dishwasher

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 27, 2006 at 12:37 pm #18741
    kevo74
    Participant

    Hi all,

    I’ve just moved house and i have the above integral dishwasher fitted & I have no instruction mannual. I’ve used it several times and now when i try to use it it will not work. After i shut the door there is about a 15 second silence and then it beeps. When you open the door the button on the far right hand side flashes on and off and you then cannot do anything apart from turning it off. I’ve read comments about resetting it and mopping out the tray at the bottom. As i have no instructions i’m not sure what to do. Can someone please help…… 😕 i’m using tablets, is this also a problem?

    June 27, 2006 at 2:38 pm #180199
    Dave_Conway
    Participant

    Re: Diplomat ADP 8322 Dishwasher

    Is the light just flashing constantly or is there a sequence to it ?

    It sounds like the usual NTC error to me, if it’s just pulsing on and off, type “NTC and Whirlpool” (exactly that without the quotes) and you’ll find plenty of info on this fault 🙂

    Dave.

    June 28, 2006 at 5:11 pm #180200
    kevo74
    Participant

    Re: Diplomat ADP 8322 Dishwasher

    Thanks Dave,

    After further reading on the site it appears to be a F4 error. It keeps returning to the rinse cycle and then beeps and flashes. Can you tell me what the error is? Thanks 😀

    June 28, 2006 at 5:31 pm #180201
    Dave_Conway
    Participant

    Re: Diplomat ADP 8322 Dishwasher

    F4 is not draining 😉

    This could be caused by any number of failures but check for blockages etc, power off if going inside :zap: or if you’re unsure, please check the repairs@ link below for a local engineer 🙂

    Dave.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.