FEW10 spin problem

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › FEW10 spin problem

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 27, 2006 at 8:07 pm #18754
    PIP-pm-
    Participant

    Got an few10 machine in everything looks fine visually pcb no blow marks all harness is fine, but it will not hit it’s fast spin it cuts off too early to end cycle any ideas anyone.

    June 27, 2006 at 9:35 pm #180259
    iadom
    Moderator

    Re: FEW10 spin problem

    I assume you mean a Hotpoint FEW10 ?

    I will send you diagnostics info for WMT02, it has the exact same PCB so it should be of some use.


    Jim.

    June 29, 2006 at 7:38 am #180260
    PIP-pm-
    Participant

    Re: FEW10 spin problem

    Oppps yes it was a hotpoint and thanks for stuff in the email really usefull.

    But got machine in work shop and it has worked fine ever since so difficult one to trace fault now

    June 29, 2006 at 9:30 am #180261
    iadom
    Moderator

    Re: FEW10 spin problem

    Check for loose tacho magnet, sometimes the machine needs to warm up before the magnet starts to slip on the shaft. A bit of loctite and a sharp tap usually does the trick.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.