Hotpoint WD72P

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WD72P

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • June 28, 2006 at 4:52 pm #18776
    Penguin45
    Participant

    Attended this recently – display not working. Diagnosed faulty control board (p/no 1604282) and replaced. Just been back for “unable to set dryer” complaint. When dryer button pressed, display comes up “Time Saver”!

    What have I missed here? There was no configuration sheet with the board, just a note saying that one programme worked differently.

    Thanks,
    Chris.

    June 28, 2006 at 4:57 pm #180341
    recall
    Participant

    Re: Hotpoint WD72P

    power up whilst pressing abc+d if i remeber it should come up wm100 press a until you get wd1200 and press start a couple of times, job done.

    June 28, 2006 at 8:45 pm #180342
    Penguin45
    Participant

    Re: Hotpoint WD72P

    Thank you, I will go and push buttons tomorrow.

    Chris.

    June 28, 2006 at 10:19 pm #180343
    iadom
    Moderator

    Re: Hotpoint WD72P

    Sorry I missed this Chris, hospital visits, a game of squash and the tea to make afterwards.

    With the machine switched OFF
    Press & hold A B & D buttons, Press the On button and the display will show WM1000, press the A key to scroll through the model options until you get to WD1200, press the START button ( the display will show ENGLISH)press again and display will show SELECT PROGRAMME. Config is now complete.

    Jim.

    June 28, 2006 at 11:37 pm #180344
    Penguin45
    Participant

    Re: Hotpoint WD72P

    Thanks Jim – will hit “print” at this point………
    Chris.

    June 29, 2006 at 7:40 pm #180345
    Penguin45
    Participant

    Re: Hotpoint WD72P

    That worked a treat, thanks both. Does beg the question why there isn’t a cheat sheet in the box…..

    Chris.

    June 29, 2006 at 8:38 pm #180346
    johnnyj
    Participant

    Re: Hotpoint WD72P

    Because we have an emit and can look it up

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.